Texas Instruments TPS560430QEVM Converter Evaluation Module (EVM)
Texas Instruments TPS560430QEVM Converter Evaluation Module (EVM) is a fully assembled and tested circuit for evaluating the TPS560430-Q1 series step-down converters. The TPS560430QEVM operates from 7.5V to 3V input (12V nominal) and provides a 5.0V output at 600mA. The evaluation board has a jumper connector to enable or disable the converter operation. The evaluation board also has AC signal injection terminals for loop measurements.
Features
7.5V to 36V Input Voltage RangeAccurate 5V Output
Texas instruments Newest
Texas Instruments LM5155EVM-FLY Controller Evaluation Module (EVM) showcases the features and performance of the LM5155 as a wide input non-synchronous flyback controller.
Date: 2019-09-26Texas Instruments TPS560430QEVM Converter Evaluation Module (EVM) is a fully assembled and tested circuit for evaluating the TPS560430-Q1 series step-down converters.
Date: 2019-09-26Texas Instruments TPS62840-1xxxEVM5x Converter Evaluation Modules (EVMs) facilitates the evaluation of the TPS6284x family of 750mA, step-down converters with 60nA IQ.
Date: 2019-09-25Texas Instruments TPS6284x High-Efficiency Step-Down Converters come with ultra-low operating quiescent current of typically 60nA.
Date: 2019-09-25Texas Instruments TPS92682EVM-070 Evaluation Module (EVM) features a two-channel, constant current boost, and boost-to-battery regulator based on the TPS92682 dual-channel controller with SPI interface device.
Date: 2019-09-25Texas Instruments TPS92682EVM-069 Evaluation Module (EVM) features a two-phase, constant voltage boost regulator based on the TPS92682 dual-channel controller with SPI interface.
Date: 2019-09-25Texas Instruments TPS92682-Q1 Dual-Channel Peak Current-Mode Controller is programmable to operate in constant-voltage (CV) or constant-current (CC) modes.
Date: 2019-09-25Texas Instruments PGA460PSM-EVM Proximity-Sensing Evaluation Module (EVM) is a small-form-factor solution showcasing double-sided printed circuit board (PCB) spacing and the supporting component requirements for the PGA460.
Date: 2019-09-24